![]() Quite some time ago during some emission’s failures I sought a way to interact with my greddy emanage blue. I had tried other DIY’s but they were somewhat unclear and I never had results. Scottradeelite online. I set out to see the full picture and work with the right parts instead of hoping that a specific usb phone cable would be the part I was looking for. Here, and I must say I’m a bit late with this older system, I will try my best to provide a detailed description on the wiring and a guide on how to achieve the creation of this cable which would otherwise cost over 150$ USD from Greddy dealers. The Greddy Emanage cable is NOT just a simple USB-USB, and it is also not the run of the mill usb-serial connector. What it really is, is described later. Guide Requirements: -Basic wiring/soldering skills -Laptop with Windows XP (or similar) -Willingness to buy parts from eBay (Rs232 TTL converter) -Spare USB cable to cut up (USB-A, the flat rectangular kind) Step 1 – Acquire Parts You will need a USB-A cable, just one end. If you can, find an older piece of computer equipment you dont need (i.e. A mouse) and cut the end off, leave as much length as you can. Flexisign 8 torrent. The other piece of the puzzle is a 5-volt RS232 to TTL Converter. These are rather common and can be found locally if you have a good electronics shop, otherwise eBay works great. There are hundreds of these listed, often below $10.00 USD (shipping included). The standard serial port communicates with voltages levels -/+10v, however communication with the Emanage requires a range of 0-5v as it is a. You will need one of these that will accept an operating voltage of 5 volts. Step 2 – Construct Strip your usb cable, there will be a foil and/or braided meshjust below the plastic. Using your hands pull this back and unravel it to reveal the four wires on the inside.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |